Stars & Stripes Sale on American-Made MuscleShop Now

Performer RPM Engine Camshaft And Lifter Kit #7122 For Small-Block Ford 289-302 V8

$428.95
Edelbrock part #7122 Performer RPM Camshaft is designed for small-block Ford 289-302 V-8 applications. This Edelbrock cam kit produced 367 HP & 340 ft-lbs. of torque when used with #7121 intake and #60259 cylinder heads on a 302 engine.
TEMPORARILY OUT OF STOCK
SKU
7122
Edelbrock Part # 7122 Performer RPM Camshaft is designed for small-block Ford 289-302 V-8 applications. This Edelbrock cam kit produced 367 HP & 340 ft-lbs. of torque when used with #7121 intake and #60259 cylinder heads on a 302 engine. The camshaft works well with high-performance street applications, Performer RPM cams provide power from 1500 to 6500 rpm. This hydraulic lifter camshaft is dyno-matched to Performer RPM manifolds for high-rpm horsepower while still maintaining acceptable low-end torque. With 10 to 12 inches of manifold vacuum at idle, Performer RPM cams have more lift and duration than most street camshafts. Hydraulic flat tappet lifters are included with each Performer RPM camshaft. Camshaft Specifications: 芒鈧垄 Duration @ .050 Intake: 224 degrees 芒鈧垄 Duration @ .050 Exhaust: 234 degrees 芒鈧垄 Lift @ Valve Intake: .496芒鈧聺 芒鈧垄 Lift @ Valve Exhaust: .520芒鈧聺 芒鈧垄 Lobe Separation: 112 Degrees 芒鈧垄 Intake Centerline: 107 Degrees 芒鈧垄 Idle Vacuum @ 1000 RPM's: 11芒鈧聺
More Information
Manufacturer Edelbrock
Application Application Specific
UPC 00085347071227
Lifter Materials Hardened Steel
Computer Controlled Compatible No
Intake Duration .050 Inch Lift 224 deg
Availability Note Available to Order
Warranty 12 Months
Emissions Code
Hazardous Materials Warning WARNING: This product can expose you to Chromium, which is known to the State of California to cause cancer or birth defects or other reproductive harm. For more information, visit www.P65warnings.ca.gov.
Installation Notes
  • Recommended Valve Springs for OEM heads: Edelbrock part # 5722
  • Not for 1985-later engines with roller lifters.
  • Screw-in studs, guide plates and adjustable rocker arms required.
  • For non-computer controlled vehicles
  • Use only stock ratio rocker arms
  • Adjustable valvetrain required
  • In order for this Performer RPM cam and lifter kit to be covered under ANY WARRANTY you MUST use the correct Edelbrock Sure Seat Valve Springs or equivalent.
  • Do not use rotator type valve springs or retainers for this application.
  • Oil/additive must contain Zinc designed for use with flat tappet camshafts.
  • Coat cam lobes and bottoms of each lifter with MoS2 lube (supplied) to prevent cam lobe and lifter wear from occurring during initial start-up.
  • Do not allow the engine to run under 2000 rpm for the first 1/2 hour. Slow idle speeds may result in severe cam and lifter wear. Start the engine and bring to break-in rpm.
Advertised Exhaust Duration 300 deg
Advertised Intake Duration 290 deg
Intake Valve Lift 0.496 in
Lifter Type Hydraulic
Lobe Separation 112 deg